Version 5.0

Version 5.0 is based on the Cyclone IV board described here.

BOM and CPL provided do include all DIP sockets using the 'hand soldering' service from JLC. Here you only need solder a few parts yourself (see below), purchase the DIP chips and the SD card and place them on the board.

For easy replacement all chips placed at the 'corners' of GottFA80 are in DIP format.

GottFA80 v5.0 preassembled by JLCPCB
GottFA80 v5.0 complete

Parts needed

In addition to the preassembled PCB you need the parts from the Reichelt shop cart and this FPGA board and an 'USB Blaster' for being able to program the FPGA.

As JLCPCB has no 2x64 pin female headers there are only two 2x32 female headers on the PCB. You need to solder half of the female headers yourself and shorten them a bit so that two female headers do fit side by side.

In addition you need to solder 2x64  header pins to the FPGA!

For the ICs there are already sockets on the PCB, no soldering needed here.

Parts from the Reichelt shop cart and the CycloneIV FPGA

Dokumentation & Software

Due to copyrigth on Gottlieb roms the SD card does not contain any rom code, but do provide the right struture for GottFA80. Have a look at the user manual to see how you can copy your rom images onto the Sd card.

how to order your GottFA80 PCB

Have a look to the PCB documentation section.

Needed Gerber Data, BOM and Component Placement List (CPL) you find on my repository server; see link below.